Full Boar FBT-0500, Instruction Manual

4

Congratulations on purchasing a Full Boar Rotary Hammer. 
Your Full Boar Rotary Hammer Drill Kit FBT-0500 has been 

designed to rapidly drill, chip, chisel and break masonry 

products such as concrete.
Read and understand the Owner’s Manual before operating 

the generator. Failure to do so could result in personal injury 

or equipment damage.

INTRODUCTION

WARNING! 

When using mains-powered tools, basic safety precautions, including the 

following, should always be followed to reduce risk of fire, electric shock, personal injury 

and material damage.

Read the whole manual carefully and make sure you know how to switch the tool off in an emergency, 

before operating the tool. Save these instructions and other documents supplied with this tool for 

future reference. The manufacturer cannot accept any liability for damage or accidents which arise 

due to a failure to follow these instructions and the safety information.

This product has been designed for 230V and 240V only. Always check that the power 

supply corresponds to the voltage on the rating plate. 

Note:

 The supply of 230V and 240V is 

interchangeable for Australia and New Zealand.

This tool is double insulated in accordance with AS/NZS 60745-1;  

therefore no earth wire is required.

The power supply for this product should be protected by a residual current device (rated at 30mA or 

less). A residual current device reduces the risk of electric shock.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared cord 

available through the service organization.
Note: Double insulation does not take the place of normal safety precautions when operating this 

tool. The insulation system is for added protection against injury resulting from a possible electrical 

insulation failure  

within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool. Before use, inspect 

the extension lead for signs of damage, wear and ageing. Replace the extension lead if damaged or 

defective.
When using an extension lead on a reel, always unwind the lead completely. Use of an extension lead 

not suitable for the power input of the tool or which is damaged or defective may result in a risk of fire 

and electric shock.

ELECTRICAL SAFETY