Full Boar FBT-0500, Instruction Manual

9

CHOOSING AN OPERATION MODE

The Full Boar FBT-0500 has 4 different operating modes: drilling, hammer drilling, chiselling 

with fixation and chiselling without fixation. Follow the below instructions to select your 

desired mode of operation.

Hammer Drilling 

Rotate the side mode selector to the 

drill icon, and rotate the rear mode 

selector to the hammer icon. This 

setting is recommended for use when 

drilling holes in concrete and other 

masonry products. The hammer 

action will be in operation while 

simultaneously the drill bit rotates.

Chiselling (free rotation)

Rotate the side mode selector to the 

free rotation chiselling mode & rotate the 

rear mode selector to the hammer icon. 

This setting is helpful when you want to 

have the chisel in a particular position. 

The bit will stop rotating once contact is 

made with the material, or you can rotate 

the bit by hand. Once you have found 

the ideal position, you can change to 

chiselling (locked) for continual use.

Drilling 

Rotate the side mode selector to the 

drill icon, and rotate the rear mode 

selector to the no hammer icon. 

This setting is recommended for use 

when you desire  the accessory to 

rotate without hammer action. Ideal 

 for drilling into timber or steel when 

correct accessories  for such materials 

are used.

Side Mode 

Selector

Rear Mode 

Selector

Chiselling (locked)

Rotate the side mode selector to the 

chisel icon,  and rotate the rear mode 

selector to the hammer icon. This 

setting is recommended for use when 

you desire  a hammer action without 

the accessory rotating which is ideal 

for “chiseling or chipping” away at 

masonry products, pick  or chisel 

accessory bits should be used.