Full Boar FBT-0700, Instruction Manual

6

– Wear ear protectors. Exposure to noise can cause hearing loss.

– Use auxiliary handle(s), if supplied with the tool.

 Loss of control can cause personal injury.

– Hold power tool by insulated gripping surfaces, when performing an operation where the 

cutting accessory may contact hidden wiring or its own cord.

 Cutting accessory contacting a “live” 

wire may make exposed metal parts of the power tool “live” and could give the operator an electric 

shock.

WARNING! 

This appliance is not intended for use by persons 

(including children) with 

reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless 

they have been given supervision or instruction concerning use of the appliance by a person 

responsible for their safety.

Recommendations for the use of a residual current device

 with a rated residual current of 30mA or 

less.

•   Before drilling into walls, ceilings etc, ensure there are no concealed power cables or pipes in the 

cavity.

•   Always use the side handle, this gives you greater control if the accessory should become jammed.
•   Keep the cord clear of the accessory being used, do not wrap the cord around your arm or wrist.
•   Hold the tool by the insulated gripping surfaces when performing an operation where the accessory 

may contact hidden wiring or its own cord.

•   Use thick cushioned gloves and limit the exposure time by taking frequent breaks.
•   Vibration caused by the hammer action may be harmful to your hands and arms.
•   When removing an accessory from the tool avoid contact with skin and use proper protective gloves 

when grasping the bit or accessory. Accessories may be hot after prolonged use.

GENERAL POWER TOOL SAFETY WARNINGS

c.    Disconnect the plug from the power source and/or the battery pack from the power tool 

before making any adjustments, changing accessories, or storing power tools. 

Such preventive 

safety measures reduce the risk of starting the power tool accidentally. 

d.   Store idle power tools out of the reach of children and do not allow persons unfamiliar with 

the power tool or these instructions to operate the power tool.

Power tools are dangerous in 

the hands of untrained users. 

e.    Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts 

and any other condition that may affect the power tool’s operation. If damaged, have the 

power tool repaired before use.

Many accidents are caused by poorly maintained power tools. 

f.    Keep cutting tools sharp and clean. 

Properly maintained cutting tools with sharp cutting edges 

are less likely to bind and are easier to control. 

g.   Use the power tool, accessories and tool bits etc. in accordance with these instructions, 

taking into account the working conditions and the work to be performed.

 Use of the power 

tool for operations different from those intended could result in a hazardous situation. 

5. Service 

a.    Have your power tool serviced by a qualified repair person using only identical replacement 

parts. 

This will ensure that the safety of the power tool is maintained. 

ROTARY HAMMER DRILL SAFETY WARNINGS