10
Fitting the wheels
Note.
You must fully assemble the compressor before using it
for the first time.
1.
Turn the compressor onto its side (Fig. 1).
2.
Insert an axle bolt (23) through one of the wheels (3)
(Fig. 2).
3.
Place one of the flat washers on the end of the axle bolt
(23), (Fig. 3).
• Examine the machine for signs of transit damage. If damaged, do not use, return to
place of purchase
• The compressor should be set up near the user.
• Avoid long air lines and long supply lines (extensions).
• Make sure the intake air is dry and dust-free.
• The compressor may only be used in suitable rooms (with good ventilation and an
ambient temperature from +5°C to +40°C). There must be no dust, acids, vapours,
explosive gases or inflammable gases in the room.
• The compressor is designed to be used in dry rooms. The compressor cannot be used in
areas where work is conducted with sprayed water. Before you use
the machine, make sure that the mains voltage complies with the specifications on
the rating plate.
• The oil level in the compressor pump has to be checked before putting the equipment
into operation.
PRE-SETUP CHECKS
ASSEMBLY
Fig. 1
Fig. 2
Fig. 3
WARNING!
During assembly, ensure the compressor is switched OFF.
