14
Switching on/off
1.
Plug the electrical cord into the power point and turn on (Fig. 21).
2.
To switch ON the
compressor, pull up
the switch (9) (Fig. 22).
3.
To switch OFF the
compressor, press the
switch (9) down (Fig. 22).
Preset pressure
The tank pressure is set at the factory and is not serviceable.
• Switch-on pressure 8 bar
• Switch-off pressure 10 bar
Note.
When the maximum preset pressure is reached, the motor will automatically switch
off. As the compressed air is used up by the connected air tool, the pressure will drop until
it reaches the preset minimum pressure. When it does, the motor will automatically begin
operating again.
Adjusting the pressure
1.
With the desired tool attached to the quick lock regulated
air outlet (5), switch on the compressor by pulling up the
on/off switch (9). The tank will begin to pressurize. The
level of the tank pressure can be read in the tank pressure
gauge (13) (Fig. 23).
2.
Turn down the locking collar to allow adjustment.
3.
You can adjust the level of output pressure by turning the
pressure regulating knob (8). To increase the air pressure,
rotate the regulating knob clockwise. To decrease the
pressure, rotate the regulating knob anti-clockwise (Fig. 24).
4.
Turn the locking collar again hard up against regulating
knob to prevent pressure drift.
5.
The regulated pressure level is displayed on the adjustable
pressure gauge (7) (Fig. 25).
Note.
Air must be flowing through the quick lock regulated
air outlet in order to obtain the correct output reading on the
regulated pressure gauge.
When adjusting the pressure lower - it is best to go below the
desired pressure, then adjust back up.
OPERATION
Psi
Bar
10
8
6
4
2
0
50
100
150
200
12
14
Psi
Bar
10
8
6
4
2
0
50
100
150
200
12
14
Psi
Bar
10
8
6
4
2
0
50
100
150
200
12
14
Psi
Bar
10
8
6
4
2
0
50
100
150
200
12
14
Psi
Bar
10
8
6
4
2
0
50
100
150
200
12
14
Psi
Bar
10
8
6
4
2
0
50
100
150
200
12
14
Psi
Bar
10
8
6
4
2
0
50
100
150
200
12
14
Psi
Bar
10
8
6
4
2
0
50
100
150
200
12
14
Fig. 21
Fig. 22
Fig. 23
Fig. 24
Fig. 25
OFF
ON
WARNING!
The air compressor must be used with a residual current device with a
rated residual current of 30mA or less.
