16
TROUBLESHOOTING
Problem
Cause
Solution
The compressor
does not start
1. No supply voltage
1. Check the supply voltage,
the power plug and the
socket-outlet.
2. Insufficient supply voltage
2. Make sure that the
extension cable is not
too long and is of suitable
current capacity..
3. Outside temperature is
too low
3. Never operate with an
outside temperature of
below +5°c.
4. Motor is overloaded
4. Allow the motor to cool
down. If necessary,
remedy the cause of the
overheating.
The compressor starts but
there is no pressure in the
tank
1. Leak in the non-return
valve
1. Replace the non-return
valve
2. The seals are damaged.
2. Check the seals and
have any damaged seals
replaced by a service
centre
3. The drain cock leaks.
Reseat safety valve.
3. Tighten the screw by
hand. check the seal on
the screw and replace if
necessary.
The compressor starts,
pressure is shown on the
pressure gauge, but the
tools do not start.
1. Loose hose connections
1. Check the compressed
air hose and tools and
replace if necessary.
2. Leak in a quick-lock
coupling
2. Check the quick-lock
coupling and replace if
necessary.
3. Insufficient pressure set on
the pressure regulator.
3. Open the pressure
regulator further.
