TRACKMASTER
Ch. 1
Introduction
317-160-284 Rev 6
TMX428 Owner’s Manual
15
February 2021
Responsibility of the Manufacturer
Full-Vision Inc. is responsible for the effects of safety, reliability, and performance of the
treadmill only if the following conditions are met:
•
Assembly operations, extensions, readjustments, modifications, or repairs are carried out by
authorized personnel.
•
The electrical installation of the relevant room complies with the requirements of the
appropriate local, state, and other government regulations.
•
The equipment is used in accordance with the instructions for use.
Responsibility of the Customer
The customer is responsible for providing appropriate desks, chairs, electrical wall outlets,
network connections, analog phone lines, and locating any of the system components described in
this manual in compliance with all local, state, and national codes.
The customer is solely responsible for the training, instruction, supervision and safety of all users
of the TMX428 and TMX428CP, and to use it as intended by the manufacturer. This device is
intended to be used as a motion appliance to facilitate cardiac or VO
2
medical evaluation.
Read this Operator’
s Manual before operating the TMX428 and TMX428CP.
Assist in off-loading the patient in the event of abnormal or unexpected operation of the treadmill.
If the treadmill is not responding properly, stop the treadmill, assist in removing the patient off
the running belt, unplug the treadmill power supply, and seek factory authorized repair before
attempting to restart the treadmill.
Never allow children or pets near the machine without qualified adult supervision.
Note the location of stop and/or emergency stop controls and their operation before starting a test
or workout.
This device is not intended for use by persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Verify the Patient and Operator understands how to stop the machine in the event of malfunction
or emergency.
Patient should not wear loose fitting nylon material when exercising on this treadmill to avoid
generating Electro Static Discharge.
Never attempt to remove any article of clothing while the running belt is moving.
All persons on and around the treadmill must wear enclosed, protective footwear. Shoe laces must
be tight and not drape as to cause a trip or catch hazard. Sandals, flip flops, slippers and the like
are not considered enclosed, protective footwear.
Walk in the center of the running belt. Contact with the side rail and the moving belt could cause
injury.
The Patient must always wear the Stop Tether lanyard wrist strap while operating the TMX428
and TMX428CP.
Place the treadmill on a hard, level and unobstructed surface. See Chapter 5 of this manual.
Check input power cord connection and location for hazardous pinch points before use.
Check input communications cord connection (if equipped) for proper interface with all
equipment.
Summary of Contents for TRACK MASTER TMX428
