TRACKMASTER
Ch. 7
Parts List with Part Numbers
317-160-284 Rev 6
TMX428 Owner’s Manual
55
February 2021
Exterior Care
The powder-coat finish on your treadmill is an extremely durable finish and requires
minimal care. Do not allow perspiration to build up on your treadmill. Wipe the unit
daily. (Refer to Appendix B Reprocessing Instructions)
Elevation Screw Lubrication
The Elevation Screw must be cleaned and lubricated every 6 months to maintain
proper operation of the treadmill. Failure to perform this maintenance function will
result in premature wear and ultimate failure of the lift mechanism.
This procedure requires the following tools:
TRACKMASTER
®
grease (Part # 317-160-165)
Clean, lint-free cloth
Small paint brush
1.
Raise the treadmill to its maximum elevation.
2.
Turn the main power switch to the OFF position, and unplug the treadmill from
its outlet.
3.
Using a lint-free cloth, remove the old lubricant and accumulated dust from the
elevation screw.
4.
Use a small brush to reapply a thin coat of grease to the threads of the elevation
screw. Do not use too much grease
—
the excess could squeeze onto the floor and
create a slip-and-fall hazard.
5.
Plug treadmill power cord back into the power source outlet. Cycle the main
power switch to the ON position and allow the treadmill to return to the parked
position.
6.
Return the unit to service.
Running Deck Maintenance
The TRACKMASTER
®
running deck is maintenance
–
free and offers (2) running
deck surfaces to double the life of ordinary treadmills.
NOTE: Do not use silicone sprays to wax your treadmill deck. Using silicone sprays will
void the warranty. Such sprays can bring about surface changes that may result
in hesitation or excessive belt slip.
If running deck surface becomes grooved due to wear, it can be renewed by
flipping the deck to the opposite side.
Summary of Contents for TRACK MASTER TMX428
