Features:
Drive
: This 11 position (detented) potentiometer adjusts the Bias of the FET’s....treat this like a Preamp
Volume knob on a Master-Volume tube amplifier. You may hear a little scraping noise when you turn this
knob....that’s ok, it’s just the sound of the FET’s rebiasing and NOT a noise problem at all.
Setting this Pot lower by
turning the knob CCW
(counter clockwise) yields very neutral, honest tones and
very little thickening of the original notes.
Setting this Pot higher by
turning the knob CW
gently clips the FET’s (like cranking the output of a tube
amp) and adds fatness, even order harmonics, and a little more Treble. (hi-end frequencies) You will
achieve more overall volume at higher
Drive knob
settings.
Tone:
This is a passive high-end (Treble) roll-off in case you want to “Brown” up
the sound. Full CW takes the tone control out of the circuit, turning it CCW will attenuate the
Treble....neutral really depends on many factors including
Drive knob
setting and Amp volume &
settings. I find 12 O’clock to be good setting most of the time.
Volume:
This knob determines the amount of signal that exits the pedal.
Sample settings: Clean Boost
Drive= 11 O’clock
Volume= 1-5 O’clock
Tone= 12 O’clock
Tube amp Overdrive
Drive =Full CW
Volume=10-12 O’clock
Tone= ’O’clock
Warranty:
Fulltone products carry a 5 year warranty to the original owner with proof of purchase. The Warranty covers damage by our errors
only, and not any mod or repair done by anyone other than Fulltone without prior written consent! Footswitches are warranted for 5
year, and batteries are not covered. Customer pays shipping in advance, and all warranty work must be preceded by a phone call
for scheduling and you must use our Return Authorization Form (RA Form) available via email or fax. Fulltone Musical Products Inc. is
not responsible for injuries incurred while using our products nor any damage to other items related or non related to the use of our
products
DC Power Options
You may run this pedal on the (supplied) 9 volt battery OR on ANY voltage
between 9 and 18 Volts DC
as long as
the adapter is (standard) 2.1mm size with Center-Pin/
Negative...You'll be amazed at the sonic differences; The higher the voltage, the cleaner, louder, and more
dynamic the sound.
Warning!
Warranty is voided if any damage occurs due to your use of anything but
a standard 9 volt DC/ Negative Center Pin configured adapter (our FPS-1 is a great one!)
Fulltone Musical Products Inc
.
4220 Glencoe Ave. Marina del Rey, CA 90292
310.821.4500 fax 821.4511
www.fulltone.com email: support@fulltone.com
Copyright 2003 FMP Inc. All rights reserved
