1. Position the extractor on level ground, in a convenient and safe area. Ensure
that the extraction arm will easily reach the operators workplace and the front
wheels are locked.
MF HEPA & MF Eco HEPA
1. Check the power supply cable for damage, if any damage is visible, it must only be replaced by the manufacturer or qualified
electrician to avoid a hazard.
2. Check that the extraction arm hose is not split or damaged, as this will reduce the efficiency of the unit.
3. To protect against electrical shock, do not immerse the power supply cable, plug or extractor in water or other liquid.
4. Our extractors are designed for interior use only and should not be used outside in wet conditions.
SAFE OPERATION
2. Insert supply cable plug into an appropriate electrical socket. Ensure that the
supply cable is not a trip hazard to anyone and turn on the main switch located
at the rear of the unit.
3. The extraction hood should be aimed at the source of the welding fumes/gases
or grinding dust (MF Eco HEPA only). This should be within a distance of 400mm
away and positioned to draw the fumes/gases away from the operators face.
AIRFLOW METER (Optional extra)
If the extractor is fitted with an optional airflow meter, this
should show a chevron or tick when the unit is switched on. If a
cross still shows after 30 seconds of switching on the unit, this
indicates low airflow.
NB. The model of Airflow meter may differ from the unit shown.
GOOD AIRFLOW
POOR AIRFLOW
CLEANING THE EXTRACTOR
Before any cleaning is undertaken, please ensure the extractor is turned off and disconnected from the mains power supply. The
main unit and extraction arm may be wiped with a damp cloth and mild detergent. Do not use abrasive cleaners or solvents as
this could damage the extraction arm hosing.
BEFORE USE
