Press
[Mode]
or
[Up]
|
[Down]
repeatedly until the display shows
‘Pro’
. Press
[Setup]
to then
select with
[Up]
|
[Down]
one of the programmes
‘Pr01’
to
‘Pr12’
.
A preprogrammed automatic show can only be activated when the unit is operating in stand-
alone mode or as master in a master / slave combination. This setting is only relevant if the
device is not controlled via DMX.
If you select
‘Pr01’
, you can press
[Setup]
and then use
[Up]
|
[Down]
to select 15 programmed
colour patterns that are constantly lighting. Or you select
‘-OFF’
to blackout the unit. Press
[Setup]
to then select with
[Up]
|
[Down]
the strobe frequency from
‘FS01’
(slow) to
‘FS99’
(fast)
or
‘FSFL’
(strobe effect). Select
‘FS00’
for constant light.
Programmes
‘Pr02’
‑
‘Pr12’
offer preprogrammed colour sequences. After selecting one of
these programmes, press
[Setup]
to then select with
[Up]
|
[Down]
the speed of the colour
sequences from
‘SP01’
(slow) to
‘SPFL’
(fast). Press
[Setup]
to then select with
[Up]
|
[Down]
the
strobe frequency from
‘FS01’
(slow) to
‘FS99’
(fast).
Press
[Mode]
or
[Up]
|
[Down]
repeatedly until the display shows
‘d---’
. Press
[Setup]
to then
select with
[Up]
|
[Down]
the desired DMX address between 1 and 512 (the display shows
‘d001’
…
‘d512’
). Make sure that this number matches the configuration of your DMX con‐
troller.
This setting is only relevant when the device is controlled via DMX.
Press
[Setup]
to then select with
[Up]
|
[Down]
the DMX mode (2, 4, 6 or 8 channels).
Programme mode
DMX address
Operating
30
SePar QUAD LED RGB UV IR, SePar QUAD LED RGBW IR
LED PAR
