function Innovation & Technology AS
- 6 -
Manual – KNX MultiLight Art.nr 44001
Doc.no. D-TS-ML-K-005-A
3
MultiLight start-up and general functions
KNX MultiLight can be configured by using the ETS Tools Software. The product database
file for KNX MultiLight can be downloaded from http://www.function.no/MultiLight.
Documentation for the parameters, objects and example configurations can be found in
the chapters below.
The MultiLight controller can be set in learn-mode by pressing the learning-mode switch
on the KNX node or by pressing the learn button on the movement detector. The
locations of the buttons are shown with red circles in Figure 2.
Figure 2 - Learn mode buttons
The red programming LED on the KNX node and inside the lens of the movement
detector will be lit when the KNX MultiLight is in learn mode. The programming LED will
blink when the MultiLight is not programmed (un-programmed node).
The node will check communication with movement detector and panel. If
communication has failed the object “Device self-test status” will be set to “1”.
When the error situation is cleared the “Device self-test status” object changes its value
to 0.
The startup procedure for a unit that has not been programmed with ETS includes
switching on the relay and showing motion detection with the red LED. This ensures that
not programmed units will turn on the light automatically.
Use a small circular object like a paper clip or a bare KNX copper wire to reach the
programming button on the movement detector.