Field
Description
IP Address / Netmask
Only for Address Mode =
-%
With Add, add a new address entry, enter the IP Address and
the corresponding Netmask of the virtual interface.
Interface Mode
Only for physical interfaces in routing mode.
Select the configuration mode of the interface.
Possible values:
•
3$$
(default value): The interface is not assigned for a
specific purpose.
•
+$$ 820*"
: This option only applies for routing inter-
faces.
You use this option to assign the interface to a VLAN. This is
done using the VLAN ID, which is displayed in this mode and
can be configured. The definition of a MAC address in MAC
Address is optional in this module.
MAC Address
Only with virtual interfaces and only for Interface Mode =
3!
$$
Enter the MAC address associated with the interface. For virtual
interfaces, you can use the MAC address of the physical inter-
face under which the virtual interface was created, but this is not
necessary. You can also allocate a virtual MAC address. The
first 6 characters of the MAC are preset (but can be changed).
VLAN ID
Only for Interface Mode =
+$$ 820*"
This option only applies for routing interfaces. Assign the inter-
face to a VLAN by entering the VLAN ID of the relevant VLAN.
Possible values are
(default value) to
.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu
Field
Description
DHCP MAC Address
Only for Address Mode =
1@4
.
If Use built-in is activated (default setting), the hardware MAC
12 LAN
Funkwerk Enterprise Communications GmbH
150
bintec Rxxx2/RTxxx2
