Field
Description
The function is enabled with
#/
.
The function is enabled by default.
Local IP Address
Only for IP Address Mode =
-%
.
Enter the static IP address you received from your provider.
Route Entries
Only if IP Address Mode =
-%
Define other routing entries for this connection partner.
Add new entries with Add.
•
; 0&&
: IP address of the destination host or
network.
•
*&
: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
•
(%
: The lower the value, the higher the priority of the
route (range of values
...
). The default value is
.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu
Field
Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
fault value is
.
Maximum Number of
Dialup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are
to
.
The default value is
.
Authentication
Select the authentication protocol for this Internet connection.
Select the authentication specified by your provider.
Possible values:
•
0
(default value): Only run PAP (PPP Password Authentic-
ation Protocol); the password is transferred unencrypted.
Funkwerk Enterprise Communications GmbH
17 WAN
bintec Rxxx2/RTxxx2
275
