Field
Description
The function is activated by selecting
#/
.
The function is enabled by default.
You can override the encryption in order to view the communic-
ation for debugging purposes.
Location
Displays the stated locality of the AP. You can enter another
locality.
Fields in the Wireless module1 or in the Wireless module 2 menu.
Field
Description
Vendor Mode
Displays the mode in which the wireless module is to be oper-
ated. You can change the mode.
Possible values:
•
?
(default value): The wireless module is not active.
•
0%%&&
:The wireless module is used as an access
point in your network.
•
1 /
: Uses the setting that was defined in the wireless
module profile.
Active Radio Profile
Displays the wireless module profile that is currently selected.
You can select another wireless module profile from the list if
more than one wireless module profile are being set up.
Channel
Displays the channel that is assigned. You can select another
channel.
The number of channels you can selected depends on the
country setting. Please consult the data sheet for your device.
Access Point mode
Configuring the network name (SSID) in Access Point mode
means that wireless networks can be logically separated from
each other, but they can still physically interfere with each other
if they are operating on the same or closely adjacent wireless
channels. So if you are operating two or more radio networks
close to each other, it is advisable to allocate the networks to
different channels. Each of these should be spaced at least four
13 Wireless LAN Controller
Funkwerk Enterprise Communications GmbH
166
bintec Rxxx2/RTxxx2
