Chapter 4 Basic configuration
You configure your device using the Funkwerk Configuration Interface .
The way to obtain the basic configuration is explained below step-by-step. Detailed know-
ledge of networks is not necessary. A detailed online help system gives you extra support.
The Companion DVD also supplied includes all the tools that you need for the configura-
tion and management of your device.
4.1 Presettings
4.1.1 Preconfigured data
Your device is shipped with a pre-defined IP configuration:
• IP Address:
• Netmask:
Use the following access data to configure your device in an ex works state:
• User Name:
• Password:
Note
All bintec devices are delivered with the same username and password. As long as
the password remains unchanged, they are therefore not protected against unauthor-
ised use. Make sure you change the passwords to prevent unauthorised access to
your device!
How to change the passwords is described in
on page 14.
4.1.2 Software update
Your device contains the version of the system software available at the time of production.
More recent versions may have since been released. You can easily perform an update
with the Funkwerk Configuration Interface in the Maintenance->Software
&Configuration menu.
4 Basic configuration
Funkwerk Enterprise Communications GmbH
10
bintec Rxxx2/RTxxx2
