which conditions the Actions are to be carried out. A Trigger may be a single event or a
sequence of events which are combined into an Event List. You also create an event list
for a single event, but it only contains one event.
Actions can be initiated on a time-controlled basis. Moreover, the status or accessibility of
interfaces or their data traffic may lead to execution of the configured actions, or also the
validity of licences. Here also, it is possible to set up every MIB variable as initiator with any
value.
To take the event scheduler live, enable the Schedule Interval under Options. This inter-
val species the time gap in which the system checks whether at least one event has oc-
curred. This event is used as the initiator for a configured action.
Caution
The configuration of actions that are not available as defaults requires extensive know-
ledge of the method of operation of bintec gateways. An incorrect configuration can
cause considerable disruption during operation. If applicable, save the original config-
uration on your PC.
Note
To run the event scheduler, the date configured on your device must be 1.1.2000 or
later.
21.7.1 Trigger
The Local Services->Scheduling->Trigger menu displays all the event lists that have
been configured. Every event list contains at least one event which is intended to be the ini-
tiator for an action.
21.7.1.1 New
Choose the New button to create more event lists.
21 Local Services
Funkwerk Enterprise Communications GmbH
442
bintec Rxxx2/RTxxx2
