Page 5
All tubes must be fully inserted
until contact is made with
adjoining tube.
CORRECT INSERTION INTO FITTINGS - (indicative diagram shown)
CORRECT TIGHTENING METHOD OF GRUB SCREWS - (indicative diagram shown)
Gap.
No gap.
CLUNK
1. With long end of allen key, hand
tighten grub screw as much as possible.
2. Using other end of the allen key do one full
360 degree turn as a minimum, use muscles!
ASSEMBLY TIPS
o
+ 360
CORRECT TIGHTENING METHOD OF RUNG BOLTS - (INDICATIVE DIAGRAM SHOWN)
1. With long end of allen key, hand tighten bolt
hard up against washer and outside of tube.
Hold rung to avoid rotation.
2. Using short end of the allen key fully tighten,
approximately 3-4 full turns .
o
3-4 turns
