13
Guide configuration transmitter for Moskito70
By default, factory-built aircraft had been installed for flight, but you must configuration compatible
your channel transmitter.
Guide configuraton transmitter :
Step 1
: Open
Betaflight
and Connect Moskito70 via USB port.
Step 2
: Go to
Receiver
tab, change your kind Transmitter at
Channel Map
box.
Which FrSky we choose
Default
at
Channel Map
.
Step 3
: Configure value for each channel.
Check Gimbal of transmitter so like as the picture, if have wrong please
Reverse channel
on Transmitter.
- Push 2 gimbal your transmitter DOWN – LEFT, channel ROLL, PITCH, YAW, THROTTLE on interface of
Betaflight go to Min = ~ 1000.
Summary of Contents for Moskito 70
Page 1: ...1 MOSKITO 70 BNB 70 size FPV racer Rev FrSky...
Page 7: ...7...
Page 17: ...17...
Page 20: ...20...
