14
F1000-UPS OWNER’S MANUAL
VOLTAGE
Requests the input and output voltages
Send Query to UPS:
?POWER<CR>
Action:
Voltage status messages will be displayed
Response:
$VOLTS_IN = vvv<CR>
$VOLTS_OUT = vvv<CR>
$WATTS = xxxx<CR>
$VA = xxxx<CR>
xxx is expressed in decimal format. If the value is less than 100, the hundreds digit is represented with a 0. For example a line volt-
age of 92VAC would be expressed as: $VOLTAGE = 092<CR>
LOAD LEVEL STATUS
Requests the load level, expressed as percentage of maximum.
Send Query to UPS:
?LOADSTAT<CR>
Action:
Load level will be displayed
Response:
$LOAD = xxx<CR>
xxx is the load level (percentage of maximum load) expressed in decimal format. If the value is less than 100, the hundreds digit is
represented with a 0.
BATTERY LEVEL STATUS
Requests the battery level, expressed as a percentage of maximum (full charge).
Send Query to UPS:
?BATTERYSTAT<CR>
Action:
Load level will be displayed
Response:
$BATTERY = xxx<CR>
xxx is the battery charge level (percentage of maximum charge) expressed in decimal format. If the value is less than 100, the hun-
dreds digit is represented with a 0.
LIST CONFIGURATION
Requests a list of all configurable parameters and current settings.
Send Query to UPS:
?LIST_CONFIG<CR>
Action:
List of configurable parameters and current settings will be displayed.
Response:
$BTHRESH = level<CR>
$BUZZER = mode<CR>
$AVR = mode<CR>
$FEEDBACK = mode<CR>
$LINEFEED = mode<CR>
$BRIGHTNESS = xxx<CR>
$SCROLL_MODE = xxx<CR>
$SLEEP_MODE = xxx<CR>
Summary of Contents for F1000-UPS
