Furman Sound, LLC 1690 Corporate Circle • Petaluma, CA 94954 • USA • www.FurmanSound.com
THE SOLUTION TO POWER YOUR APPLICATION...
You’ve got a rack for your effects, preamps, tuner...You’re going to plug that into the wall? One big spike and your
rig is up in smoke. Furman’s standard level surge/spike protection defends your gear from the spikes and surges
that are so common at gigs and practice spots. With Furman’s standard level RFI/EMI fi ltration, you’ll get a quieter
tone without pops, crackles, and the local radio station coming out of your amp. Plus, dual pull-out lamps (M-8Lx/M-
8Dx) let you see your rack without turning the house lights on, while the digital voltmeter (M-8Dx) lets you monitor
incoming voltage.
Can’t track down where that noise is coming from? Your mix sounding fl at? With Furman’s standard level RFI/EMI
fi ltration you’ll lower the noise fl oor caused by the dirty AC power coming into your console or DAW. Furman’s
standard level surge and spike protection keeps your sensitive digital equipment from acting funny or burning up
due to everyday spikes and surges. You can even monitor voltage changes, as the digital meter (M-8Dx) allows you
to keep an eye on the incoming line voltage. With a 15A capacity and nine total outlets, it’s enough to power your
whole home studio.
Bars, clubs and other event venues have some of the worst power out there - from air compressors turning on and off
to light shows pulling current loads up and down, the AC power can be a strain on the circuits in your rig. Furman’s
standard level protection and fi ltration keeps the bad stuff out and the digital voltmeter (M-8Dx) lets you monitor the
incoming line voltage. The dual pull-out front panel lights (M-8Lx/M-8Dx) let you discreetly see your board and gear
without distracting from the show on the dance fl oor.
When you’re out there gigging, you never know what kind of power you’re going to get. The wear and tear on mobile
rigs eventually takes it toll - that’s why it’s smart to plug into Furman’s standard level protection and RFI/EMI fi ltration.
It keeps your equipment safe and sounding clean, while the digital voltmeter (M-8Dx) lets you monitor incoming
voltage. Whether you’re setting up a show at the local club or powering up the church band for their next service,
make sure you give them power they can trust.
INSTRUMENT RIGS
RECORDING
DJ EQUIPMENT
PRO AUDIO
Maximum Output Current
15 Amps
Line Cords
6 ft. captive, 14 AWG, with 3-conductor Edison Plug
Lamps (M-8Lx/M-8Dx)
Two 120V incandescent bulbs, 4 watts each
Operating Voltage
120VAC 60Hz
Spike Protection Mode
Line to neutral
Energy Dissipation
150 Joules
Peak Impulse Current
12,000 Amps
Maximum Continuous Operating Voltage
130 VAC RMS
Noise Attenuation (Transverse Mode)
M-8x²: Greater than 23db, 200Khz to 10MHz
M-8Lx: Greater than 26db, 200Khz to 10MHz
M-8Dx: Greater than 26db, 200Khz to 10MHz
Dimensions
1.75” H x 19” W x 3.75” D (M-8x²)
1.75” H x 19” W x 7.5” D (M-8Lx/M-8Dx)
Weight
M-8x²: 4.9 lbs. (2.2 kg)
M-8Lx/M-8Dx: 6 lbs. (2.7 kg)
Three Year Limited Warranty
Merit Series units are protected by a limited three year
warranty covering defects in materials and workmanship.
MERIT X SERIES SPECIFICATIONS
