Furrion DV3050, Instruction Manual

7. LOC BUTTON

1) In RADIO mode, when the signal of the distance radio station are very weak and the receiving

effect is bad during tuning, press 

LOC 

button on the remote control to turn off the LOC function,

then tune again for the distance radio station;

2) In RADIO mode, when the signals from the local radio stations are too strong, this could lead

to interference. Press

 LOC 

button on the remote control to turn on the LOC function,

Re-tune for the local station required.

8. To search for stations with a PTY (PROGRAM TYPE) program

Press and hold 

button on the front panel to select one of PTY programs:

SEL 

            PTY MUSIC------------------------    PTY NEWS  

1. POP M, ROCK M

1. NEWS, AFFAIRS, INFO

2. EASY M, LIGHT M

2. SPORT, EDUCATE, DRAMA

3. CLASSICS, OTHER M

3. CULTURE, SCIENCE, VARIED

4. JAZZ, COUNTRY

4. WEATHER, FINANCE, CHILDREN

5. NATION M, OLDIES

5. SOCIAL, RELIGION, PHONE IN

6. FOLK M

6. TRAVEL, LEISURE, DOCUMENT

     When turning on a PTY program, the PTY program and PTY word is flashed on LCD.

     After selecting a desired PTY program and no operation for 5 seconds, it will search 

     for the station of the PTY program. During 1 loop, if the desired station of the PTY 

     program is not found, it returns to previous normal radio and PTY icon disappears.

9. AF [ALTERNATIVE FREQUENCIES] FUNCTION

When  AF switching mode is selected the state of AF switching mode is displayed by AF

segment in display.

          Segment off: AF switching mode off.

          Segment on: AF switching mode on, and has RDS information.

          Segment flashing: AF switching mode on, but RDS information is not received yet.

     When AF switching mode is selected, the radio checks the signal strength of AF all the 

     time. The interval of checking time of each AFs depends on the signal strength of  the 

     current station, from a few minutes for strong station to a few seconds for weak station. 

     Every time that new AF is stronger than current station, it switches over to that frequency

     for a very short time, and the NEW FREQUENCY is displayed for 1-2 seconds. 

     Because the mute time of AF switching or checking time is very short, it is almost 

     inaudible in case of normal program.

     During FM mode, when AF is on, SEEK, (SCAN), AUTO-MEMORY function can only 

      receive and save RDS program. 

10. TA [TRAFFIC ANNOUNCEMENT] FUNCTION

When TA mode is on(TA is displayed on LCD), it will begin to seek TA station and TA 

SEEK will be displayed on LCD for a while.

When traffic announcement is transmitted:

1). If the unit is in SD, USB mode, it will switch to radio mode temporarily.

2). If volume level is below 20, volume level is raised to 20, and returns to its previous 

     mode and volume level when the traffic announcement is over. 

     If volume is adjusted during traffic announcement, only the traffic announcement 

     volume is valid

PAGE 5

CCD-0005532 | REV DATE: 11.29.22