3. BERTHING DISPLAY
3-2
3.2
Display Range
3.2.1
How to select a range
The display range is the distance between grid sides on the berthing display. Use the
RNG
key to select a range. The range appears below the 3-axis speed display as
shown below. The system is pre-set with five ranges (nm): 0.025, 0.04, 0.05, 0.075
and 0.1. A total of 11 ranges are available and you can select the ranges to use from
the menu, as shown in the next section.
3.2.2
How to pre-set ranges
The berthing display has a total of 11 ranges. Select the ranges to use, following the
procedure shown below. A minimum of one range must be turned on.
1. Press the
MENU/ESC
key to open the menu.
2. Select [Set Up Scale] then press the
ENT
key.
3. Select [Range] then press the
ENT
key.
4. Select a range then press the
ENT
key. Show
“X” in a check box to select the range, or remove
the “X” to deselect the range.
5. Press
T
to show and select [Save] then press
the
ENT
key.
Note:
If all ranges are turned off, the message
"No item be selected" appears. Select at least
one range.
6. Press the
DISP
key to close the menu.
Display
range
0.050 NM/DIV H UP
0.01
12.45
0.31
SOG m/s
Grid
Set with
RNG
key
Range
Summary of Contents for DS-60
