6. MAINTENANCE, TROUBLESHOOTING
6-13
5) Select [Start] then press the
ENT
key. The display now shows the echoes from
the beams (or channels) selected.
5. To change the range, press the
RNG
key. The available ranges are (in meters) 5,
10, 20, 40, 100, 200 and 300. The current range is shown at the bottom right cor-
ner on the echo monitor display.
6. To clear the echo data, press the
DISP
key.
7. The [Setting] menu controls the gain, TX mode and exit from the echo monitor. At
the echo monitor display, press the
MENU/ESC
key to show the [Setting] menu.
1) You can change the gain to see the echoes under different gain settings.
Select [Gain] then press the
ENT
key.
2) Use
S
or
T
to set the gain then press the
ENT
key.
3) [TX Mode] on the [Setting] menu stops or starts transmission. [ON] transmits,
[OFF] stops transmission. Use [OFF] to monitor noise.
Echoes appear
here.
Echoes appear
here.
Echoes appear
here.
Summary of Contents for DS-60
