3. TARGET TRACKING (TT)
3-28
[TRIAL
MANEUVER]
1 BACK
2 TRIAL
OFF/STATIC/DYNAMIC
3 TRIAL SPEED RATE
0kn 0.00kn/s
0kn 0.00kn/s
4 TRIAL TURN RATE
0kn 0.0°/s
0kn 0.0°/s
3. Select 4 [TRIAL MANEUVER].
TRIAL MANEUVER menu
4. Select 2 TRIAL.
5. Select STATIC or DYNAMIC as appropriate. The TRAIL box appears at the
upper right corner.
TRIAL OFF
6. Select 3 TRIAL SPEED RATE. Set trial speed rate with the scrollwheel, in the
upper box.
7. Select 4 TRIAL TURN RATE. Set trial turn rate with the scrollwheel, in the
upper box.
Note:
Two sets of trial speed and trial turn rate combinations are provided.
Enter the data by sets as shown in the figure below. This is done to
provide accurate trial maneuver results for various ship’s speed.
3
TRIAL SPEED RATE
4
TRIAL TURN RATE
Set 1
0kt
0.00kn/s
0kt
0.00kn/s
Set 2
Set 1
0kt
0.0
°
/s
0kt
0.0
°
/s
Set 2
Set speed and turn rate to
zero (0) to simulate
course and speed changes
not affected by ship’s
inertia.
8. Push the right button three times to close the menu.
9. Use the trackball to select the TRIAL box and push the left button. Then, the
TRIAL box reads TRIAL SET and boxes appear above the TRIAL box as
below.
86.8
°
T
06.5kn
00:30
DELAY
TRIAL SET 00:00
Course for trial maneuver
Speed for trial maneuver
Delay time for trial maneuver
Trial time
Boxes for setting trial maneuver parameters
10. Use the scrollwheel to set delay time at DELAY. This is the time after which
own ship takes a new situation, not the time the simulation begins. Change
the delay time according to own ship loading condition, etc. Use the
scrollwheel to set the delay time.
11. Select the course setting box. Use the scrollwheel to set the course
