1
1.
MOUNTING
1.1
Processor Unit
1.1.1
Installation considerations
The processor unit can be installed on a desktop or a bulkhead. When selecting a
mounting location, keep in mind the following points:
• Locate the unit out of direct sunlight.
• Select an installation location that is well ventilated.
• Locate the unit where shock and vibration are minimal.
• Leave sufficient space around the unit for maintenance and service.
• Face the cable connectors downward for bulkhead mounting.
• Keep in mind the compass safe distances shown on page i.
1.1.2
Tabletop mounting
1) Drill four pilot holes in the tabletop for the self-tapping screws.
2) Screw four self-tapping screws (
φ
5x20, supplied) into the pilot holes, leave 5 mm
protruding.
3) Set the processor unit to the screws, then slide the processor unit to the front to fix
the unit.
4) Fasten the screws to fix the unit in place.
1.1.3
How to bulkhead mount the processor
1) Drill four pilot holes in the bulk-
head for the self-tapping screws.
2) Screw four self-tapping screws
(
φ
5x20, supplied) to the pilot
holes, leave 5 mm protruding.
3) Hang the processor unit on the
screws. The cable connectors
should be faced downward.
4) Fasten the screws to secure the
unit in place.
㻞㻤㻜
㻝㻢㻜
Face the cables
downward
Summary of Contents for FCV-1900
