3. ADJUSTMENTS
3-3
3. Click [CONNING - PORT], then input the distance from the port line to the conning
position.
Reference point
Select the antenna position (refer to section 3.9) or CCRP (Consistent Common Ref-
erence Point) as the radar reference point.
1. Open the [MAIN]>[CONFIGURATION]>[OPERATION] menu.
2. Click [REF POINT].
3. Click [ANT] or [CCRP] as reference point.
3.4
How to Adjust Sweep Timing
Sweep timing differs with respect to the length of the signal cable between the antenna
unit and the processor unit. Adjust sweep timing at installation to prevent the following
symptoms:
• The echo of a “straight” target (for example, pier), on the 0.25 NM range, will appear
on the display as being pulled inward or pushed outward. See the figures below.
• The range of target echoes will also be incorrectly shown.
1. Set the controls as shown below:
GAIN: 80, STC: 0, RAIN: 0, FTC: OFF
2. Open the [MAIN]>[CONFIGURATION] menu.
3. Click [INSTALLATION] to show the [INSTALLATION] menu.
L1: Ship length
W1: Width of hull
L2: Conning position (from bow)
W2: Conning position (from port)
W1
L1
L2
W2
Conning position
(1) Correct (2) Target pushed inward (3) Target pushed outward
Image of a straight pier with different sweep timings
Summary of Contents for FR-1908V-BB
