3-1
3. ADJUSTMENT
AND
CHECK
3.1
Hull Unit Check
After the installation, confirm that the LED in the raise/lower control box of the
hull unit does not light. If it lights, turn off power at ship’s mains and reconnect
two lines of U, V or W lines of the power cable.
Note:
Before conducting this check (at the dry dock) transmission must be
stopped.
Default setting of TX transmission is OFF. Confirm as follows.
1. Turn on the power, and then press the [MENU] key to show the main menu.
MENU
QUIT
H-SCAN SETTING...
V-SCAN SETTING...
OTHERS...
TX PULSE LENGTH-H
: 9
TX POWER-H
: 9
TVG-NEAR-H
: 0
TVG-MEDIUM-H
: 0
TVG-FAR-H
: 0
AGC-H
: 0
2ND AGC-H
: 0
ECHO AVERAGE-H
: 0
COLOR-H
: COLOR 1
COLOR RESPONSE-H : COLOR CURVE 3
Main menu
2. Use the trackball to select OTHERS and press the [MENU] key.
OTHERS
MENU
QUIT
QUIT
ES1 SETTING...
ES2 SETTING...
ERASE MARKS...
DISPLAY SETTING...
FISH ALARM & AUDIO...
PRESET, MEMORY CARD...
INITIAL SETTING...
OTHERS menu
Summary of Contents for FSV-24
