1. OPERATIONAL OVERVIEW
1-2
1.2
Turning the Power On/Off
1.2.1
Turning the power on
Press the POWER ON (|) switch. A beep sounds, the lamp above the switch
lights, and the last-used mode is presented.
Note:
The example screens shown in this manual may not match the screens
you see on your display. The screen you see depends on your system
configuration and equipment settings.
1.2.2
Turning the power off
1. First retract the transducer with the
[ ]
key. The lamp above the switch blinks
while the transducer is being raised and lights steadily when it is fully raised.
Note:
While raising the transducer, the ship speed must be as below to
prevent damage to the transducer and the hull unit.
1200 mm stroke: 15 kts or less
1600 mm stroke: 12 kts or less
2. Press the POWER OFF ( ) switch for more than one second, after the
[ ]
key lights steadily.
Note:
The transducer is automatically retracted into the tank if the POWER
OFF ( ) switch is pressed before retracting the transducer. However,
for safety purposes, make it a habit to retract the transducer before
turning off the power.
TRANSDUCER
POWER
POWER ON key
POWER OFF key
Retraction key
Mid protrusion key
Full protrusion key
POWER & TRANSDUCER key
Summary of Contents for FSV-30
