2. WIRING
2-3
Transducer cable
• The transducer cables (10S2320, 16 pcs) are secured on the cable securing plate.
After installation of the hull unit, release the transducer cables from the cable secur-
ing plate for wiring. The cable securing plate can be removed and discarded after
releasing the transducer cables.
• If the transducer cables are not quite long enough, unfasten the cable clamp to re-
lease the cables.
• When the transducer is removed from the hull unit while installing the hull unit, re-
attach the transducer and route the transducer cables as shown in the following fig-
ure.
Transducer cable
(10S2320, 16 pcs.)
Cable clamp
Cable securing plate
Max.
150 mm
100 mm
Max.
150 mm
100 mm
340 mm
Transducer cable routing layout
View from “A”
Cable tie
(CV-350N)
Cable clamp 2 (2 pcs)
Cable clamp 1 (2 pcs)
Cable fixing rubber (6 pcs)
㸿
2 1
Inside
Outside
Cable length
1100 mm travel
1
2
1020 mm
870mm
920 mm
770 mm
800 mm travel
Note
: Hang down the transducer cable
to eliminate the cable tortion, then
measure the cable length. Make sure
that the cables are not contacted with
the raise/lower shaft when it is moving
(Tolerance: +0 mm, -20 mm).
Fastening torque:
196 to 215N
・
m
Transducer cable
Summary of Contents for FSV-85-MARK-2
