9. MAINTENANCE
9-2
9.2
Hull Unit Maintenance
Care for the hull unit by following the procedures shown below.
Note 1:
Do not mix SEATENDER 20 with SEA GRANDPRIX 660HS, or apply one
over the other.
Note 2:
It is possible to remove SEATENDER 20 and replace the coating with SEA
GRANDPRIX 660HS. To remove the current coating, soak a nylon-based scrubbing
pad in thinners, then apply the thinner to the coating in a washing motion. To prevent
damage to the transducer, do not use tools (scrapers, etc) or sandpaper to remove the
coating.
Hull Unit
Apply MOLYTONE grease
#2 every six months.
Raise transducer and coat main
shaft with Daphne Grease MP
No.2 (IDEMITSU KOSAN
CO.,LTD.*1) every six months.
Coat gear shaft with Daphne
Grease MP No.2 (IDEMITSU
KOSAN CO.,LTD.*1) every six
months.
Dry dock ship and clean transducer
face yearly. Apply single coat of
"SEATENDER 20"
*2
anti-foulant to
transducer face to keep marine life off
the transducer. Do not paint metallic
parts such as the transducer flange.
*
1
Equivalent greases:
SHOWA SHELL OIL: Shell Albania Grease S No
EXXON MOBIL: Mobilux EP No.2
NIPPON OIL CORPORATION: Multinox Grease
*
2
Equivalent coating (anti-foul):
CHUGOKU MARINE PAINTS, Ltd.:
SEA GRANDPRIX 660HS
If water is leaking
from the main shaft,
replace the gasket.
CAUTION
Replace anticorrosion zinc plate yearly.
Corrosion between the main shaft and transducer may result,
allowing water leakage and/or loss of transducer.
Summary of Contents for FSV85MK2
