9. MAINTENANCE
9-22
9. Use a gap gauge to measure the gap between the fixed core and the moving core.
Insert the leaf of the gap gauge horizontally to the place of measurement. Take
the measurement. Measure the gap at three places.
10. If the gap measured at step 9 is approx. 0.6 mm, do the following to reduce the
gap. (If you can insert the 0.6 mm leaf, do steps 1) to 3) below.)
1) Loosen three hex bolts to remove spacer, gap adjustment shim, bolt assem-
bly, and fixing plate.
Note:
Be careful not to drop the gap adjustment shim.
Gap gauge
Leaf
Loosen two wing screws to slide the
cover and remove the gap gauge.
Measure gap here.
Moving core
Fixed core
Fixing plate
Spacer
Gap adjustment
shim
Bolt assy.
Hex bolts
Hex bolts
Fixed core
Fixed core
Gap
Gap
Spacer
Spacer
Fixing plate
Fixing plate
Hex bolt
Hex bolt
Moving core
Moving core
Summary of Contents for FSV85MK2
