List of ACU events
B-11
08840-0 ADM WARNING Master PLL lock
The master PLL has lost lock. Check the input
reference signal.
08841-0 ADM ERROR
Tuner lock
The internal tuner PLL was unable to lock.
08842-0 ADM WARNING GSC demodulator
The GSC demodulator has reported an error.
08843-0 ADM WARNING DVBS demodulator The DVBS demodulator cannot be initialised and
loaded correctly.
08844-0 ADM WARNING BUC voltage
The BUC voltage is out of range.
08845-0 ADM WARNING LNB voltage
The LNB voltage is out of range. The LNB
might be switched off to protect the power
supply circuitry. Reactivate satellite profile to try
again, check LNB cable and surroundings if the
problem persists.
08880-0 ADM ERROR
WLAN
configuration error
Configuration of WLAN module failed.
08A00-0 ADM WARNING GX Core Module
fan
There is a problem with the Core Module fan.
Check/clean and replace if necessary.
08A01-0 ADM WARNING GX Core Module
heater
There is a problem with the Core Module heater.
Check and replace if necessary.
08A02-0 ADM WARNING GX Core Module
temperature
The Core Module temperature is out of range.
This may affect performance, and the Core
Module will be shut down if the situation gets
worse. If the "GX core module heating" event is
also present, the internal heater is currently
warming up the unit to its operational
temperature.
08A03-0 ADM ERROR
GX Core Module
The Power Good signal from the Core Module is
low. Check cables.
08A04-0 ADM WARNING iDirect modem
The ACU detected a warning/error in the iDirect
modem. Log into the modem for more
information.
Info: 0x00000001: Temperature error
0x00000002: Test error 0x00000004: Fan error
08A05-0 ADM WARNING GX Core Module
heating
The GX core module heater is active. It will
automatically be cleared when the core module
reaches the operational temperature level.
Error
code
(ID)
ACU
PCB
Severity
Description
Explanation
Table B-2: ACU event messages (Continued)
Summary of Contents for FV-110GX
