6. NAVIGATION
6-10
6.3
Following a Route
You can follow a route as follows.
Setting a complete route as destination
This method enables you to navigate from the first waypoint of a route.
1. Press the cursor pad to place the cursor at the location not occupied by waypoint.
2. Press the [TLL/GOTO] key to show the GO TO window.
3. Rotate the [ENTER] knob to choose ROUTE and then push the [ENTER] knob to
show the SELECT ROUTE window.
Select route window
4. Rotate the [ENTER] knob to choose a route which you want to set as destination.
5. Push the [ENTER] knob.
Setting part of a route as destination
You can start the route navigation from any waypoint in a route.
1. Open the route list.
2. Press the cursor pad (
S
T
) to choose the route desired.
3. Rotate the [ENTER] knob to choose PLOT at the bottom of the screen, and then
push the [ENTER] knob.
The plotter display appears.
4. Press the cursor pad to place the cursor on any waypoint which is part of the route
you want to set as destination.
5. Press the [TLL/GOTO] key.
A line runs between destination selected and own ship's position. Also, range and
bearing from own ship's position to destination appear in the data window.
You can change the destination in the route by pressing the PREV or NEXT soft
key.
1 0001RT
2 0002RT
3 0003RT
4 __________
5 __________
6 __________
7 __________
8 __________
9 __________
10 __________
SELECT ROUTE
ROUTE NAME
www.reelschematic.com
www.reelschematic.com
