3. CUSTOM SCREEN
3-13
3. Use the Cursorpad (
S
or
T
) to select [Style] and use the Cursorpad (
X
) to move
the cursor to the right.
4. Press the
ENT
key.
E.g. [Locked HDG]
5. Use the Cursorpad (
S
or
T
) to select [Current Heading] or [Current Bearing] then
press the
ENT
key.
6. Press the
DISP
key to close the menu and display the data screen.
Note 1:
See section 3.4 for instructions on changing the direction mode. If the heading
or bearing is locked, it is unlocked when you change the direction mode.
Note 2:
You can perform this operation in the [System] menu (see section 7.6).
Digital screen
To display only the value for the locked heading or the locked bearing in zoomed for-
mat, change the analog format to digital format.
1. With the [Locked HDG] or [Locked BRG] screen displayed, press the
ENT
key.
2. Press the
ENT
key long.
3. Use the Cursorpad (
S
or
T
) to select [Style] and press the
ENT
key.
4. Use the Cursorpad (
S
or
T
) to select [Digital] and press the
ENT
key.
5. Press the
DISP
key to close the menu and display the data screen.
E.g. [Locked HDG] - [Digital]
Summary of Contents for RD-33
