9-1
9.
OTHER FUNCTIONS
9.1
Entering Ship’s Position Manually
Ship’s speed is normally input by the navigator connected to the radar. If the navigator fails
enter ship’s position manually as follows:
1. Press the [MENU] key.
2. Press the [1] key twice to show the Video Plot/AIS menu.
3. Press the [0] key twice to choose AIS/Miscellaneous1.
4. Press the [7] key twice to choose Miscellaneous2.
MIscellaneous2
1.
↑
2. Pos. Sensor
Navaid Manual
3. Own Ship Pos.
00
°
00.000'N
000
°
00.000'E
4. Display All Card Data
5. Delete Data
6. All Delete
N, E; + S, W: -
Miscellaneous2 menu
5. Press the [3] key to choose Own Ship Pos.
6. Key in latitude position of ship. (Use the [-] key to switch latitude coordinate from North
to South; [+] from South to North.)
7. Press the [ENTER/SELECT] key.
8. Key in longitude position of ship. (Use the [-] to switch latitude coordinate from East to
West; [+] from West to East.)
9. Press the [ENTER/SELECT] key.
10. Press the [2] key to choose Manual.
11. Press the [ENTER/SELECT] key to register your selection.
12. Press the [MENU] key to finish.
Summary of Contents for RP-180
