2. OPERATION
2-9
DISABLE SV (Disable satellite)
Every GPS satellite is broadcasting abnormal satellite number(s) in its Almanac,
which contains general orbital data about all GPS satellites. Using this
information, the GPS receiver automatically eliminates any malfunctioning
satellite from the GPS satellite schedule. However, the Almanac sometimes may
not contain this information. If you hear of an inoperative satellite you can
disable it manually. Enter satellite number in two digits and then press the
ENT
key. To restore a satellite, enter “00”.
2.8 Output
Data
2.8.1 Heading
Heading data is output from the DATA OUT port on the processor unit, in IEC
61162-1/2 format.
1. Press the
MENU
key to open the menu.
2. Choose I/O SETUP and then press the
ENT
key.
OUTPUT DATA SETUP
DATA OUT1: AD-10
DATA OUT2: AD-10
DATA OUT3: IEC
DATA OUT4: IEC
DATA OUT5: IEC
LOG PULSE: 200 P/NM
OUTPUT DATA SETUP menu
3. Choose DATA OUT1 and then press the
ENT
key.
IEC
AD-10
Data out options
4. Use the
Omnipad
to choose AD-10 or IEC as appropriate and then press the
ENT
key. If you choose AD-10, no further operation is required; go to step 18
to finish. For IEC go to the next step.
DATA OUT1
SENTENCE: HDG VTG ROT
BAUD RATE: 4800BPS
INTERVAL: 100mS
NMEA VER: IEC ED2
HDG TALKER: GP
HDT HDM
GLL ZDA VHW VBW
DATA OUT1 menu
