3. MAINTENANCE, TROUBLESHOOTING
3-10
Error messages (con’t from previous page)
Error Message
Meaning
Remedy
BATTERY ALM!
Voltage of battery in processor
unit is low.
Have battery replaced at
earliest convenience.
DATA ERR!
GPS data (from the GPS receiver
in the processor unit) is lost for
one minute. Heading output is
stopped and the heading
indication shows “- - -“.
Check GPS receiver.
DGPS ERROR!
DGPS data (from external DGPS
receiver) is lost for one minute.
Ship may not be within DPGS
service area.
GPS DATA ERROR!
GPS data (from internal GPS
receiver) is lost for one minute.
Heading output is stopped and the
heading indication shows “- - -“.
Conduct diagnostic test1 and
check if NG appears for results
for GPS receivers GPS1, GPS2
and GPS3.
GPS NO FIX!
No GPS data.
Check antenna cable.
HDG ERROR!
Heading error
Request service.
NO HEADING OUTPUT!
GPS heading error continues for
five* minutes. In this case the
heading indication shows “- -
-“ and heading output is stopped.
* = default setting. May be
changed by “backup” setting.
Press any key to try to restore
normal operation.
RAM ERROR!
RAM problem
Request service.
RATE ERROR(YAW)!
Data output stopped.
Request service.
RATE ERROR(ROLL)!
Data output stopped.
Request service.
RATE ERROR(PITCH)!
Data output stopped.
Request service.
COMMUNICATION ERR! Communication between display
unit and processor has been
interrupted.
Request service.
WAAS ERROR
WAAS data lost for one minute.
Request service.
ROM ERROR!
ROM problem
Request service.
*:
Alarm port goes open when message appears.
