© Copyright Fusion Sport Pty Ltd, 2018. All Rights Reserved
16
Product Support and Warranty
HOW TO GET SUPPORT
For all product support please email:
support@fusionsport.com
WARRANTY STATEMENT AND DISCLAIMER
The Fusion Sport devices are manufactured by Fusion Sport Pty. Ltd. at its Brisbane, Australia facility. The devices
have a 12-month warranty from the date of purchase. Fusion Sport warrants and represents that all Fusion devices
are free of all defects in material, workmanship and design, and have been produced and labelled in compliance with
all applicable laws, regulations and ordinances pertaining to their production and labelling. This warranty is expressly
limited to repair, replacement of product or refund of product price at the sole discretion of Fusion Sport. Equipment
for repair must be returned to the Fusion Sport facility in Brisbane, Australia or a Fusion Sport authorised repair
centre. To do this, contact Fusion Sport’s service/ repair department to obtain a Return Authorisation (RA) number.
CONSEQUENTIAL DAMAGES RELATING TO DATA LOSS, SUBSEQUENT EQUIPMENT FAILURE, AND/ OR EQUIPMENT
DAMAGE ETC IS EXPRESSLY EXCLUDED FROM THIS WARRANTY AND GRABBA INT. ACCEPTS NO LIABILITY FOR ANY
LOSS OR DAMAGE INCURRED WHAT-SOEVER.
In the event that it is determined the equipment failure is covered under this warranty, Fusion Sport shall, at its sole
discretion, repair the product or replace the product with a functionally equivalent unit and return such repaired or
replaced product without charge for service or return freight, whether distributor, dealer, or retail consumer. This
limited warranty does not extend to any product which, in the sole judgment of Fusion Sport, has been subjected to
abuse, misuse, neglect, improper installation, accidental damage, nor any damage due to use or misuse produced
from integration of the product into any mechanical, electrical or computer system. The warranty may be void if the
case of the product is opened by anyone other than Fusion Sport
’s repair department or authorised repair centres
.
Apple, iPhone and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries.
“Made for iPod iPhone iPad” means that an electronic accessory has been designed to connect specifically to iPod
touch, iPhone and iPad respectively, and has been certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or tis compliance with safety and regulatory standards.
FCC STATEMENT
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
Summary of Contents for SmartSpeed PT
Page 1: ...USER MANUAL Version 2 1...
