4
PRECAUTIONS
•
Following are important precautions to prevent damage to unit, merchandise or product.
•
Please read carefully!
CAUTION! LAMP REPLACEMENT GUIDELINES
LED lamp replacements must meet factory specifications.
CAUTION
CAUTION! ADVERSE CONDITIONS / SPACING ISSUES
•
Performance issues caused by adverse conditions are NOT warranted.
•
To prevent damage to end panels due to condensation, apply industrial grade
silicone sealant and tightly join to opposite end panels. When not adjoining
cases, keep end panels at least
6”
away from walls/structures. Rear panels
must also be kept at least
6”
from walls and structures.
•
Case must not be exposed to direct sunlight or any heat source.
•
To maintain proper case temperature, keep case at least 15
-
feet from exterior
doors, overhead HVAC vents or any air curtain disruption.
•
Self
-
contained case clearance:
6”
min. air intake /
6”
min. air discharge.
CAUTION
CAUTION! POWER CORD AND PLUG MAINTENANCE
Risk of electric shock. If cord or plug becomes damaged,
replace only with cord and plug of same type.
OVERVIEW / TYPE / COMPLIANCE / WARNINGS / PRECAUTIONS / WIRING / PLUGS
-
PAGE 2 of 2
CAUTION! GFCI BREAKER USE REQUIREMENT
If N.E.C. (National Electric Code) or your local code
requires GFCI (Ground Fault Circuit Interrupter) protection,
you MUST use a GFCI breaker in lieu of a GFCI receptacle.
WIRING DIAGRAM FORMAT & LOCATION
•
Each case has its own wiring diagram folded & in its own packet.
•
Wiring diagram placement may vary; it may be placed near ballast
box, field wiring box, raceway cover, or other related location.
SEAL FLOOR
-
MOUNTED UNITS TO THE FLOOR
•
Thoroughly clean floor to assure a secure seal!
•
Base frames or fixed (non
-
removable) cladding,
panels and/or splash guard brackets must be
sealed to floor with silicone that meets or
exceeds food grade NSF/ANSI Standard 51.
