5
INSTALLATION: PALLET REMOVAL / POSITIONING CASE / FRAME SUPPORT RAIL SHIMMING
2. Position & Align Case Alongside Other Cases
•
Before shimming frame support rails, make
certain that the case is in proper position and if
required, aligned with adjoining case.
•
This may require the repositioning of the case
you are installing or the already positioned
case.
3. Shim Frame Support Rails
•
Most cases have frame support rails.
•
Shims will be provided with all cases that have
frame support rails.
•
Use shims to level case.
•
You may need to remove front and/or rear
toe
-
kick to access frame support rails
•
Note: After case is in position, it must be
sealed to floor to prevent entry or leakage
of liquid or moisture.
•
See illustration at right.
Frame Support Rails
1. Remove Unit From Pallet
•
Caution: Case must always remain
supported or center of gravity will allow
case to fall.
•
Slide unit to rear of pallet and lean
backward off skid.
•
Slide pallet out from under case while
case is being supported.
•
See illustration at right.
Pallet
