4
5
PROGRAMMING REMOTES
1.
Turn the ignition switch ‘OFF/ON’ 3 times (within 15 seconds)
and leave in the ON position.
2.
Push the valet switch 3 times, and hold on the 3rd push until a long
chirp is heard from the siren, and then release the valet switch. You
are now in the remote programming mode.
3.
Press and hold any button of the remote until the siren responds
with a confirming chirp, this indicates the remote has been stored
into
memory.
4.
If you have additional remotes (up to 4 in total) that need to be
programmed, repeat step 3 for each remote.
Exit Programming:
Turn ignition to ‘OFF’ position, or wait for 15
seconds. Three long chirps and three indicator light flashes will
confirm exit.
Note:
This mode will only retain the last 4 remote transmitters
programmed. If the remote memory is exceeded, the security system will
start deleting remote’s from memory in chronological order.
ALARM FEATURES PROGRAMMING:
ALARM FEATURE “I” PROGRAMMING:
1.
Turn the ignition ‘switch ‘ON/OFF’ 3 times (within 15 seconds)
and leave in the OFF position on the 3rd time.
2.
Push the valet switch twice, and hold on the 2nd push until one
short chirp, followed by one long chirp is heard then release the valet
switch. You are now in the alarm feature ‘I’ programming mode.
3. A;
Press and release the remote button corresponding to the
feature ‘1’ to be changed.
The siren will chirp and the LED will indicate the new setting
B;
Press and release the remote button corresponding to the
feature ‘2’ to be changed.
The siren will chirp and the LED will indicate the new setting
C;
Press and release the remote buttons + corresponding to
the feature ‘3’ to be changed.
The siren will chirp and the LED will indicate the new setting
Note:
The factory default setting is always [1] LED flash, [1] chirp.
Press remote
button
One Chirp / LED one
flash
Factory Default
Setting
Two Chirps / LED two
flashes
1
Chirps on
Chirps off
2
Automatic Rearm On
Automatic Rearm Off
3 +
Instant Door Ajar
Warning
45 second Delay Door
Ajar warning
Exit Programming:
Turn ignition to ‘ON’ position, or wait 15 seconds.
Three long chirps will confirm exit.
