1.
Remove the Fusion R800RAID from its packaging, and place it on
a flat, level surface.
2.
Carefully pull out each of the transport shims securing the drive
modules in the enclosure.
(Figure 3)
.
3.
If you intend to place the Fusion enclosure on a desktop or other
flat surface, attach the included adhesive-backed feet to the
bottom of the enclosure.
(Figure 4)
.
4.
Push a lever release button toward the right until the lever pops
out, and then pull the lever toward you to slide out and remove a
drive module
(Figure 5)
.
5.
Carefully insert the drive module into the enclosure until it
clicks, and then push the lever in to secure the module inside the
enclosure
(Figure 6)
.
6.
Repeat steps 4 and 5 for the remaining drives.
7.
Install the Fusion R800RAID into the rack or onto the desktop
on which it will reside.
Drive Installation and Enclosure Setup
Support Note:
Save the shims! If you intend to transport the
Fusion enclosure in such a way that it will be subject to vibration,
you must reinsert the shims under the bottom of the drive modules in
order to prevent them from moving during transport.
Figure 6
Support Note:
It is possible that the drive modules may have
shifted during shipping. To ensure good connections between
the drives and their connectors, remove and reinstall each drive module
before powering on the enclosure.
WARNING:
When inserting the drive trays into the enclosure,
do not force the lever closed
. If the lever does not close
easily, remove and reinsert the tray, and then push the lever in again.
Figure 5
Figure 4
Figure 3
shim
foot
shim
shim
shim
drive tray
lever
lever release
button
shim
shim
shim
shim
push lever until
it stops
push tray in
until it clicks
4
