Operating Procedures for
V.C.I. Stand-alone Diagnosis
69
7-1-3. Error and Troubleshooting of V.C.I. Stand-alone Diagnosis
No.
Error Message / Symptom
Cause
Remedy
1
> Out of target for V.C.I. Stand-alone
diagnosis.( unregistered )
> The systems you selected are out
of target for the V.C.I. Stand-alone
diagnosis.
> The selecting systems do not exist.
1. Use the PC to make a diagnosis because
the systems you selected are not
supported for the V.C.I. Stand-alone
diagnosis.
2. Confirm that if the system you selected exists
or not.
2
> Error has happened during
communication between V.C.I. and
ECU
> Communication line between V.C.I.
and ECU got disconnected or loosed
connection from any cause
> ECU power OFF
1. Verify that the IG switch is turned ON.
2. Check if the communication wire between
V.C.I. and ECU is disconnected or not.
3. Pressing the V.C.I. “Enter” key proceeds on
the diagnosis.
<Comm. Error>
Retry ?
< Init. Error >
System not Supported
or System not exist
