Operating Procedures for Air Suspension Calibration
80
(3) Set the Lower Level
Car height on each of the front / rear can be adjusted.
For the adjustment method, please refer to the service
guide for each vehicle.
--- greatly down
--- small down
--- greatly up --- small up
--- Height sensor calibration will be complete, after
the adjustment state is set.
--- Enlarged view of the 4 buttons : go to section (5).
--- The operate mode display : go to section (4).
For ensuring safety, the declining operation is stopped
automatically by the consecutive operation in a given time.
(It stops after 3 Seconds for Front, 10 Seconds for Rear.)
Press the button again if you continue declining operation.
(4) Select the operate mode
--- Setting
--- Return to the previous screen
(5) The button display can be enlarged in order that the
up-and-down setting of car height is performed easier
without looking at a screen.
--- Front / Rear change
--- Return to the previous screen
--- The operate mode display: go to section (4).
This screen is for operating up-and-down setting of car
height, so the adjustment state cannot be fixed here.
Return to the previous screen by the button, and fix
the adjustment state by the button.
