44
Electrolux 818 22 59-03/9
To change the light bulb
The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Press the spring together and pull the grille
downward at the same time.
Use a bulb of the same type, E14 socket, maximum
rating of 25 W.
Defrosting
Defrosting is not necessary.
Every 24 hours, the evaporator is defrosted
automatically.
When the appliance is not in use
Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside
from spoiling in case of a power failure.
Something Not Working
GB
Before
contacting your local Service Force Centre check the following point:
Problem
Possible cause / Remedy
" " is displayed in the temperature
display.
Please contact your local Electrolux Service Force Centre
Audible alarm + flashing red warning
lamp.
(It is too warm inside the freezer.)
Switch off the audible alarm by pressing the alarm off button.
The audible alarm could have been triggered by:
The cabinet having been recently switched on and the
temperature still being too high. See the chapter "Switching on
and setting the temperature".
The door may have been open for so long that the `door open'
alarm was triggered.
It is too warm inside the freezer.
Set a lower temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
It is too cold inside the freezer.
Set a warmer temperature.
Action Freeze could have been switched on.
The temperature display shows the highest temperature inside
the cabinet. Thus a difference between the temperature
indicated on the display and the (average) temperature
measured in another way is normal.
Too much frost and ice are produced.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The compressor operates continuously.
Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
