INSTALLATION
WARNING!
Refer to Safety
chapters.
Positioning
CAUTION!
If you are discarding
an old appliance that has a lock
or catch on the lid, you must
ensure that it is made unusable
to prevent young children being
trapped inside.
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Cli-
mate
class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation
can only be guaranteed within
the specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer service
or to the nearest Service Centre
The appliance shall have the
plug accessible after installation.
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your domestic
power supply.
• The appliance must be earthed. The
power supply cable plug is provided with
a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a qualified
electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
1.
Put the freezer in horizontal position on
a firm surface. The cabinet must be on
all four feet.
2.
Make sure that the clearance between
the appliance and rear wall is 5 cm.
3.
Make sure that the clearance between
the appliance and the sides is 5 cm.
TECHNICAL DATA
Technical data
Height
mm
876
54
