Particularly high room temperature - no
machine fault.
Lower the room temperature if possible.
1) In case of error message on the LCD (e.g.
E51
- only dryers with the LCD): Switch the dryer off and on. Set
programme. Press the Start/Pause button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaningchapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
MACHINE SETTINGS
Setting
Implementation
BUZZER permanent off
1. Turn the programme selector to any programme.
2. Press simultaneously the
Intensiv (Intensive)
and
Extra
Knitterschutz (Long anticrease)
buttons and hold down for
approx. 5 seconds.
3. The buzzer is by default always off.
Water hardness
Water contains, a variable
quantity of limestone and min-
eral salts of which quantities
vary according to geographi-
cal locations thus varying its
conductivity values.
Relevant variations of the con-
ductivity of the water com-
pared to those prefixed by the
factory could slightly influence
the residual humidity of the
laundry at the end of the cy-
cle. Your dryer allows you to
regulate the sensitivity of the
drying sensor based on con-
ductivity values of the water.
1. Turn the programme selector to any programme.
2. Press simultaneously the
Intensiv (Intensive)
and
START/
PAUSE
buttons and hold down for approx. 5 seconds. Lights
show the current setting:
– Tank - low conductivity <300 micro S/cm
– Filter - medium conductivity 300-600 micro S/cm
– Condenser - high conductivity >600 micro S/cm
3. Press the
START/PAUSE
button sequentially until you set de-
sired level.
4. To memorize setting press simultaneously the the
Intensiv
(Intensive)
and
START/PAUSE
buttons or turn knob to
OFF
position
TECHNICAL SPECIFICATIONS
height x width x depth
85 x 60 x 58 cm
drum volume
108 l
depth with the load door opened
109 cm
adjustable height
1.5 cm
the appliance weight
52 kg
maximum load volume
7
kg
voltage
230 V
necessary fuse
6 A
total power
1050 W
energy efficiency class
A
energy consumption kWh/cycle
1)
1,85
kWh
55
Summary of Contents for PRIMOTECQ TW730E
Page 29: ...Description du modèle PNC N S 29 ...
Page 60: ...www ch 136918180 A 342011 ...
