15
*When making these setting adjustments, do so with the motor disconnected or the
engine not running.
NEUTRAL, HIGH, AND BRAKE MAX POINTS SETTINGS
Before setting each point, set the transmitter throttle channel trim to neutral.
Turn on the power in transmitter -> amp order.
1
2
Transmitter throttle operation
･
Neutral state
･
Press the pushbutton switch.
(0.5 secs or longer)
(Confirmation beep sounds)
･
Continuous single blink
MC231CR /MC331CR
(Pushbutton switch operation)
(Checker LED)
N
N
Full High
Full brake
N
Neutral point
setting
3
･
Full high state
･
Press the pushbutton switch.
(Confirmation beep sounds)
･
Continuous double blink
High point
setting
4
･
Full brake state
･
Press the pushbutton switch.
(Confirmation beep sounds.)
･
If the LED goes out,
setting is complete.
Brake MAX
point setting
Set the throttle adjustment function (EPA) to 100% and
the ABS function to OFF using the transmitter throttle
channel function.
If the throttle angle is too large or the ABS functions are on,
erroneous operation may occur.
*When using the ABS function,
after setting up the MC231CR /
MC331CR, stop the reverse
function, then turn on the ABS
function. If the ABS function is
on, the MC231CR / MC331CR
cannot be set up correctly.
(Preparations)
Select the model memory that is not used and reset it to the initial values with the model
selection and model reset functions.
Servo Horn Installation Instructions
1
Connect the receiver, servos, and other components and then turn
on the power switches to the transmitter and receiver.
*Both servos will move to the neutral position.
2
At this time install the servo horn in the manner described in the
instruction manual provided with the model this system will be used in.
Reversing The Servo Operation Direction
Should the servo operate in the opposite direction required for your application,
reverse the direction with the servo reversing.
E.S.C. MC231CR / MC331CR
Transmitter Set-Up Procedures
Model number
（
1 - 0
）
Model name
Model Reset
Push the DT1 lever right or left
for about two seconds.
All data stored in the currently
selected model memory is
erased.
Model Selection
Selection key
Throttle Servo Reverse
NOR: Normal
REV: Reverse
Direction change
NOR: Normal
REV: Reverse
Steering Servo Reverse
Direction change
Summary of Contents for 3pv-2.4g
Page 1: ...R 1M23N31504 ...
