141
Fu
n
c
ti
o
n
S.BUS Servo
2
(S.BUS/S.BUS2 servo read)
Execute this function to read the connected servo
type and the data currently set at the servo.
Tap the [Read] button. The notes on the wireless
settings are displayed. Tap the [Close] button.
Once this screen is displayed, it will not be displayed
again until you turn the power back on. Next, Touch
the channel in which the servo to be set is connect-
ed and read the setting data from the servo.
- Communication port: 7PXR communication port (conventional wired setting).
- Wireless 1 (Rx Ch1): Receiver channel 1
- Wireless 2 (Rx Ch2): Receiver channel 2
-"Reading succeeded" is displayed on the screen, and
the servo’s ID cord and currently set contents are read.
- If "Failed" is displayed on the screen, communication
with the servo is not being performed normally.
- Check the T7PXR and servo connection or receiver and
servo connection to servo and repeat [Read]. (Check
receiver power supply etc.)
3
(Writing to S.BUS/S.BUS2)
Execute this function to write the setting data to
the servo. See pages 143 to 144 for the set of
data contents. Tap the [Write]; the confirmation
screen is displayed. To execute, tap [Yes] to hear
an electronic sound and finish setting. To cancel,
select [No] and tap it.
-"Writing succeeded" is displayed on the screen, and the set-
ting data is written to the servo.
- If "Failed" is displayed on the screen, communication with
the servo is not being performed usually. Check the T7PXR
and servo connection or receiver and servo connection to the
servo and repeat [Write]. (Check receiver power supply, etc.)
4
(Initialization)
Write the factory set servo setting data to the con-
nected servo. Tap the [Reset]; the confirmation
screen is displayed. To execute, tap [Yes] to hear
an electronic sound and finish setting. To cancel,
select [No] and tap it.
-"Writing succeeded" is displayed on the screen, and then ini-
tialize a setting data is written to the servo.
- If "Failed" is displayed on the screen, communication with the
servo is not being performed usually. Check the T7PXR and
servo connection or receiver and servo connection to servo
and repeat [Reset]. (Check receiver power supply etc.)
Summary of Contents for 7PXR
Page 1: ...1 I INSTRUCTION NSTRUCTION M MANUAL ANUAL ...
Page 204: ...204 ...
